Connecting To The Adcp - Teledyne WorkHorse Deployment Manual

June 2018

Connecting to the ADCP

C
O N N E C T I N G T O T H E
Using TRDI Toolz
Connecting to the ADCP
To establish communications with the WorkHorse:
1. Connect the system and apply power.
2. Start the TRDI Toolz software.
3. Select New Serial Connection.
4. Enter the ADCP's communication settings. Select the COM Port the serial cable is connected to
and set the Baud Rate from the drop down lists.
5. Click the Connect button. Once connected, the button will change to Disconnect.
6. Click the Break (
select Soft Break (= = =). The wakeup banner will display in the terminal
window.
[BREAK Wakeup A]
WorkHorse Broadband ADCP Version 50.38
Teledyne RD Instruments (c) 1996-2010
All Rights Reserved.
>
It may be necessary to click inside the terminal window and then click the Break button to
wake up the system.
Page 6
EAR-Controlled Technology Subject to Restrictions Contained on the Cover Page.
A D C P
I N C L U D E S T H E F O L L O W I N G S T E P S
) button. From the Break button drop down menu,
WorkHorse Monitor/Sentinel Deployment Guide
: