Usage Of Nx8840 Computer Blade; Jumper Setting - Inspur NX8840 Manual

Chapter One NX8840 Computer Blade Overview
Number Name
Blade KVM Status Indicator/
A
KVM Button
B Start Button/Power Indicator
C Restart Button/Failure Indicator Lights on when blade module restarts/blade fails, red
D USB Interface

1.4 Usage of NX8840 Computer Blade

NX8840 computer blade shall use with Inspur I800 server, and computer blade
could only be used when installed in I8000 server system, about how to install NX8840
blade onto an I8000 server, please refer to related parts in I8000 server use manual or
illustration on chassis of I8000 blade server host, which is not repeated here.

1.5 Jumper Setting

Mainboard jumper setting is an operation to short circuit two pins of the jumper to
change interface functions, according to the following fi gure, so as to adjust mainboard
functions.
Figure 1-2 Blade Unit Interface and Indicator
Lights on when blade KVM is activated, blue/manual
activates current blade module KVM
Lights on when switch blade module/blade operates
normally and fl ashes when starts BMC, green
Connects USB devices
2
Status/Function