Snap-On ControlTech Micro User Instructions page 25

torque is recalibrated, calibration counter is automatically reset to zero. User can disable
calibration interval check and use number of cycles since last calibration to decide when to
recalibrate.
Note: If an invalid date is entered and Calibration interval is enabled, an unintended "CAL NEEDED"
message may be displayed. Either disable calibration interval or enter a correct date.
Change Password
Change Password function allows user to change password to a new password. Default password is
required to initially change password. Refer to ControlTech™ Micro Calibration Manual for default
password.
1. From Configure menu, use UP/DOWN buttons to highlight CHANGE PASSWD selection then press
ENTER button.
2. Initial password entry screen is displayed.
3. Enter default password if changing for first time, otherwise enter current user password using
UP/DOWN buttons to change each digit followed by ENTER button.
4. Change password entry screen is displayed.
5. Enter new password using UP/DOWN buttons to change each digit followed by ENTER button.
6. Confirm password entry screen is displayed.
7. Re-enter new password using UP/DOWN buttons to change each digit followed by ENTER button.
Note: Pressing POWER button at any time aborts password change sequence.
SET DATE/TIME
SET CAL INTRVAL
CHANGE PASSWD
Note: If an invalid password is entered during confirmation step, Invalid Password Match screen is
displayed and new password is not accepted.
INVALID
PASSWD MATCH
PRESS TO CONT.
Previous password entry screen
ENTER
ENTER PASSWD
button
0 0 0 0 0
UP/DOWN buttons
New password entry screen
ENTER
CHANGE PASSWD
button
0 0 0 0 0
UP/DOWN buttons
24
Confirm password screen
ENTER
CONFIRM PASSWD
button
0 0 0 0 0
UP/DOWN buttons