Snap-On ControlTech Micro User Instructions page 16

4. Press ENTER button to accept selection and exit to Settings menu.
EXIT
SHOW INFO
SLEEP TIME
UP/DOWN buttons
LCD CONTRAST
KEY BEEP
AUTO BACKLIGHT
ENTER
button
Toggle Backlight Setup
This function will allow user to enable or disable backlight toggle function. If toggle mode is disabled,
BACKLIGHT button turns on backlight and it automatically turns off after five seconds following any
last button press. If toggle mode is enabled, a BACKLIGHT button press will turn on backlight and it
will remain on until next BACKLIGHT button press.
1. From Settings menu, use UP/DOWN buttons to highlight
ENTER button.
2. TOGGLE BACKLGHT screen is displayed.
3. Use UP/DOWN buttons to highlight ENABLE or DISABLE (factory default) selection.
4. Press ENTER button to accept selection and exit to Settings menu.
EXIT
SHOW INFO
SLEEP TIME
UP/DOWN buttons
KEY BEEP
AUTO BACKLIGHT
TOGGLE BCKLGHT
ENTER
button
Note: Backlight will turn off when wrench powers down either by POWER button press or sleep time.
Note: If toggle backlight is enabled and backlight is on, backlight will remain on during and after
applying torque.
Vibrator Configuration
This function will allow user to configure vibrator for On or Off when target is reached for preference
and/or battery power savings.
1. From Settings menu, use UP

press ENTER button.

2. VIBRATOR CONFIG screen is displayed.
3. Use UP /DOWN



4. Press ENTER button to accept selection and exit to Settings menu.

ENTER
AUTO BACKLIGHT
button
ENABLE
DISABLE
UP/DOWN buttons
AUTO BACKLIGHT
ENABLE
DISABLE
ENTER
TOGGLE BCKLGHT
button
ENABLE
DISABLE
UP/DOWN buttons
TOGGLE BCKLGHT
ENABLE
DISABLE
 /DOWN

buttons to toggle ON or OFF selection.


TOGGLE BACKLGHT
 buttons to highlight

15
selection then press
VIBRATOR CONFIG selection then