Snap-On ControlTech Micro User Instructions page 12

8. To enter additional angle presets, repeatedly press ENTER button until target angle screen is
displayed and repeat steps above.
00
90°
Target Angle Screen
ENTER button
04
PSET 02
90°
Preset Angle Screen
Editing a Preset
Edit PSET function gives user ability to edit stored PSETS on wrench.
1. From Preset screen to be edited, press and hold UNITS button for 3 seconds.
2. CHANGE PRESET screen is displayed.
3. Highlight EDIT selection using UP/DOWN buttons then press ENTER button.
4. TARGET TORQUE or TARGET ANGLE screen is displayed. Value can be changed by pressing
UP/DOWN buttons. Once desired target torque or angle value has been set, press ENTER button.
5. MINIMUM TORQUE or MINIMUM ANGLE screen is displayed. Value can be changed by pressing
UP/DOWN buttons. Once desired torque or angle value has been set, press ENTER button.
6. MAXMUM TORQUE or MAXMUM ANGLE screen is displayed next. Value can be changed by
pressing UP/DOWN buttons. Once desired torque or angle value has been set, press ENTER button.
7. BATCH COUNT screen is displayed next. Value can be changed by pressing UP/DOWN buttons.
Once desired batch count value has been set, press ENTER button.
8. PSET target screen is displayed labeled with same PSET number.
00
90°
Target Angle Screen
ENTER button
00
PSET 02
92°
Preset Angle Screen
Note: Pressing ENTER button while
Deleting a Preset
Delete PSET function allows user to remove stored presets from wrench.
1. From Preset screen to be deleted, press and hold UNITS button for 3 seconds.
2. CHANGE PRESET screen is displayed.
3. Highlight DELETE
4. Target screen is displayed and deleted PSET is no longer available for selection.
UNIT
ADD PRESET
button
held YES
NO
UP/DOWN buttons
ADD PRESET
YES
NO
ENTER button
UNIT
DELETE
button
EDIT
held
EXIT
UP/DOWN buttons
DELETE
EDIT
EXIT
ENTER button
EXIT
menu selection using UP/DOWN buttons and press ENTER button.
UP/DOWN buttons
ENTER
TARGET ANGLE
button
90°
BATCH COUNT
4
UP/DOWN buttons
UP/DOWN buttons
ENTER
TARGET ANGLE
button
92°
BATCH COUNT
0
UP/DOWN buttons
menu selection is highlighted will exit without editing PSET.
11
UP/DOWN buttons
ENTER
MINIMUM ANGLE
button
90°
ENTER
button
ENTER
MAXIMUM ANGLE
button
94°
UP/DOWN buttons
UP/DOWN buttons
ENTER MINIMUM ANGLE
button
90°
ENTER
button
ENTER
MAXIMUM ANGLE
button
94°
UP/DOWN buttons