Louver Control - Fujitsu AS*G09KXCA Series Service Instruction

7. LOUVER CONTROL

1. VERTICAL LOUVER CONTROL
(Function Range)
Each time the Vertical SET button is pressed, the air direction will change as follow:
COOL or DRY mode
*: Default setting
At the biginning of AUTO or HEAT mode, they may stay on position 1 for a while for adjustment.
If the angle is set to position 5 - 8 for more than 30 minutes in COOL or DRY mode, the louver will autmatically
return to position 4.
(*Keeping the position 5 - 8 during COOL or DRY mode may cause of condensation water drops.)
After beginning of AUTO / HEAT mode operated and automatic defrosting operation time,
the air flow will be position 1.
The airflow direction setting will temporarily become 1 when the temperature of the airflow is low at the start of
HEAT mode.
At the beginning of AUTO mode, the position you cannot change the airflow direction.
2. HORIZONTAL LOUVER CONTROL
(Function Range)
Each time the Vertical SET button is pressed, the air direction will change as follow:
At the beginning of AUTO mode, the position you cannot change the airflow direction.
3. SWING OPERATION
(Function Range)
Set the automatic swing operation, Each time the SWING Button is pressd, the operation will change.
Up/ Down
The Left/ Right swing operation will follow the direction as shown above.
The Up/ Down Swing operation range will differ by mode as follows.
Swing operation may stop temporarily when the indoor unit fan is rotating at very low speed or is stopped.
In FAN mode, the UP/ Down swing operation range of 1
direction previously set before starting the swing operation
Horizontal air flow direction louver
*: Default setting
Left/ Right Up/ Down/ Left/ Right
COOL, DRY, or FAN mode
HEAT mode
Stop swing
HEAT or FAN mode
5 or 5 8 is decided according the airflow
01-08