Table of Contents
Advertisement
2.6 Console Port Wiring
An RS232 console port for configuration and management of the device is
located on the LED display module shown in Figure 25. This port is intended to
be a temporary connection during initial configuration or troubleshooting and
allows for direct serial access to the management console. The connection is
made using the DB9-Female to RJ45 console cable included in the device
packaging shown in Figure 26. Console connection settings are: 57600 bps, no
parity bits, 8 data bits, and 1 stop bit.
Figure 25: Console port on display board
For reference, the console cable pin-out is show in Table 6.
RuggedCom RS232 over RJ45 pin-out specification
Signal Name (PC is DTE)
DCD – Carrier detect
RxD – Receive data (to DTE)
TxD – Transmit data (from DTE)
DTR – Data terminal ready
GND - Signal ground
DSR – Data set ready
RTS – Ready to send
CTS – Clear to send
RI – Ring Indicator
Table 6: RS232 over RJ45 console cable pin-out
After initial configuration, the RSG2300 can be configured via a number of
networked mechanisms such as Telnet SSH, and the built-in secure web server.
Consult the ROS™ User Guide for further details.
Notes:
This port is not intended to be a permanent connection.
Serial cable must not exceed 2m (6.5 ft) in length.
RuggedCom®
Figure 26: RSG2000 Series
Console cable
DB9- Female
1
2
3
4
5
6
7
8
9
25
RuggedSwitch RSG2300 Installation Guide Rev108
Installation
RJ45 Male
2
5
6
3
4
1*
8
7
1*
Advertisement
Table of Contents
