Printers - Safety During Repair And Maintenance; Powders - Safety While Working With Powder - SINTERIT LISA X Translation Of The Original User Manual

2.5 PRINTERS – SAFETY DURING REPAIR AND MAINTENANCE
WARNING!
• Only trained personnel should carry out repairs.
• Read the user manual carefully before using the printer or doing any
maintenance jobs.
• During cleaning operations, maintenance jobs or when changing parts, the
power switch must be off and the machine must be unplugged by removing
the power cable from the socket.
• During maintenance jobs, affix a notice to the appliance indicating „MACHINE
BEING SERVICED, DO NOT START".
• Do not adjust controls that are not described in the manual.
WARNING!
• Structural damage and improper alterations or repairs could change the protection
capacity of the printer and therefore void the warranty.
• Any alterations to the appliance can only be made by Sinterit Support.
• In the event of Customers fitting a tool to the machine not supplied by Sinterit, make sure the
safety conditions required by Machine Directive 2006/42/CE are complied with and in any
event, Sinterit is unable to accept liability for any problems arising from the use of such a tool.
STOP!
Avoid using flammable or toxic solvents for cleaning and maintenance such as
petrol, benzene, ether and alcohol for cleaning.
2.6 POWDERS – SAFETY WHILE WORKING WITH POWDER
WARNING!
• When working with the polyamide powder or other designated printer powder
for the Sinterit Lisa X printer, always wear personal protection dedicated to
this device (protective glasses, protective gloves, protective dust mask).
• When working with powder, avoid inhalation or swallowing and contact
with skin and eyes.
ATTENTION!
• Polyamide powder should be stored in tightly closed containers (e.g Sinterit metal container),
in a room at room temperature and low humidity.
• The powder should be stored out of reach of children and pets.
• If the device is not used for a long time, the powder should be removed from the printer and
stored in a sealed package (e.g Sinterit metal container).
ATTENTION!
When printing the smell of melting material may be emitted in intensities which do not affect the
health of users. However, in the case of long-term operation of the printer in a poorly ventilated
room, the smell may become unpleasant and irritating. Adequate ventilation is recommended in
order to create the best printing conditions.
Sinterit LISA X User Manual | 8