Quantum DXi4701 User's Guide
IP Address / Network Mask
10.40.166.87
255.255.0.0
10.40.0.0
255.255.0.0
Note: If you define a single community and set both the IP
address and network mask to 0.0.0.0 (or leave both blank),
then IP address-based access control is disabled. In this
case, the SNMP agent is accessible from any IP address.
Note: When entering IP addresses, never use an address that is in
a reserved IP address range. To see a list of reserved IP
address ranges, click the quick tip icon [?] located near the
IP address field.
4 In the Access Type drop-down box, select the access type for the
community:
• Get - Allows SNMP get operations.
• Get/Set - Allows both SNMP get and put operations.
5 Select the Community status check box to enable the community.
Or clear the Community status check box to disable the
community.
6 Click Apply.
Deleting a Community
Delete an SNMP community if you no longer want the DXi4701 to
belong to a group of devices that are monitored by a common
management station.
To delete a community, select the community and click Delete.
Note: You can select multiple communities to delete at once.
Chapter 9: DXi4701 Configuration
Result
Invalid because the logical
bitwise operation (address
AND mask) is not equal to the
address
Allows access from any client
with address 10.40.xx.xx
Notifications
353