Quantum DXi4701 User Manual page 114

Chapter 4: DXi4701 Configuration Wizards
Replication Wizard
88
The Sync ID is used to identify the target partition that will
receive replicated data from the source partition. The Sync ID
must be identical to the Sync ID of the target partition on the
target system.
c Select the check box for each replication target you want to
replicate the partition to. When the partition is replicated, its
data will be sent to all selected targets.
3 To configure the partition to receive replicated data from another
DXi system, enter the following information under Receive:
a (Optional) Select the Enable Cartridge based replication to
this DXi check box to enable Cartridge Based Replication for the
partition, and then enter a Sync ID in the box.
The Sync ID is used to identify the source partition that will send
replicated data to the target partition. The Sync ID must be
identical to the Sync ID of the source partition on the source
system.
b If you enabled Cartridge Based Replication, select an Access
option:
• Locked - The partition is not allowed to receive new
Cartridge Based Replication data.
• Unlocked - The partition is allowed to receive new Cartridge
Based Replication data.
Note: You cannot configure a partition to both send and receive
Cartridge Based Replication data.
4 Click Apply.
5 (Optional) To configure additional partitions for replication, repeat
Steps 1–4.
6 Click Next to continue.
Quantum DXi4701 User's Guide