Quantum DXi4701 User Manual page 112

Chapter 4: DXi4701 Configuration Wizards
Replication Wizard
86
With Directory/File Based Replication, a file is automatically
replicated when it is closed or a period of time after it is
modified. After replication, the replicated files are immediately
available on the target system.
The Sync ID is used to identify the target share that will receive
replicated data from the source share. The Sync ID must be
identical to the Sync ID of the target share on the target system.
c Select the check box for each replication target you want to
replicate the share to. When the share is replicated, its data will
be sent to all selected targets.
3 To configure the share to receive replicated data from another DXi
system, enter the following information under Receive:
a (Optional) Select the Enable Directory/File based replication
to this DXi check box to enable Directory/File Based Replication
for the share, and then enter a Sync ID in the box.
The Sync ID is used to identify the source share that will send
replicated data to the target share. The Sync ID must be
identical to the Sync ID of the source share on the source
system.
b If you enabled Directory/File Based Replication, select an Access
option:
• Locked - The share is not allowed to receive new Directory/
File Based Replication data.
• Unlocked - The share is allowed to receive new Directory/
File Based Replication data.
Note: You cannot configure a share to both send and receive
Directory/File Based Replication data.
4 Click Apply.
5 (Optional) To configure additional shares for replication, repeat
Steps 1–4.
6 Click Next to continue.
Quantum DXi4701 User's Guide