Quantum DXi4701 User Manual page 340

Chapter 9: DXi4701 Configuration
System
314
Or select a route to edit its settings.
4 Enter the following network information as provided by your
network administrator:
• Destination - The destination network for the route.
• Dest Netmask - The network mask for the route.
• Dest Gateway - The gateway IP address used for outgoing
traffic sent from the interface to a host or client. (This is usually
not the same as the default gateway.)
Note: The destination gateway of each route must match the
subnet of at least one configured IP address listed in the IP
Address Table. If no match is found, an error displays
stating that the route's destination gateway is not
reachable.
Note: In the example shown in
10.50.50.x subnet, you would enter 10.50.50.0 for
destination network, 255.255.255.0 for the destination
netmask, and 10.20.20.1 as the destination gateway.
5 Click Update to save the changes you made to the Routing Details
table. (Clicking Update does not yet apply the new network settings
to the DXi4701.)
Click Delete to remove IP routing information for the selected
interface. Or click Undo to revert all current Routing Details changes
to the last update.
Applying Network Settings
For network changes to take effect, you must apply the changes, finalize
the confirmation, and reboot the system. To apply all changed settings
on the Network page to the DXi4701, click Apply at the bottom of the
page. Follow the prompts to confirm the changes and reboot the
system.
Note: To revert all network settings to the initial state and undo all
changes, click the Reset button.
Figure 170, to reach a host on the
Quantum DXi4701 User's Guide