Quantum DXi4701 User Manual page 377

Quantum DXi4701 User's Guide
IP Address / Network Mask
10.40.166.87
10.40.166.0
10.40.166.87
255.255.0.0
10.40.0.0
255.255.0.0
Note: If you define a single community and set both the IP
address and network mask to 0.0.0.0 (or leave both blank),
then IP address-based access control is disabled. In this
case, the SNMP agent is accessible from any IP address.
Note: When entering IP addresses, never use an address that is in
a reserved IP address range. To see a list of reserved IP
address ranges, click the quick tip icon [?] located near the
IP address field.
4 In the Access Type drop-down box, select the access type for the
community:
• Get - Allows SNMP get operations.
• Get/Set - Allows both SNMP get and put operations.
5 Select the Community status check box to enable the community.
Or clear the Community status check box to disable the
community.
6 Click Apply.
Editing a Community
Edit an SNMP community to change the IP address or access type for the
community. You can also enable or disable the community.
To edit a community:
Chapter 9: DXi4701 Configuration
Result
Invalid because the logical
bitwise operation (address
AND mask) is not equal to the
address
Invalid because the logical
bitwise operation (address
AND mask) is not equal to the
address
Allows access from any client
with address 10.40.xx.xx
Notifications
351