Quantum DXi4701 User Manual page 155

Quantum DXi4701 User's Guide
3 If it is not already selected, select the Enable Replication check box
to enable replication for the share or partition.
4 Select the Enable Directory/File or Cartridge Based Replication to
target check box to enable Directory/File or Cartridge Based
Replication for the share or partition.
Or clear the Enable Directory/File or Cartridge Based Replication
to target check box to disable Directory/File or Cartridge Based
Replication for the share or partition.
5 Enter a Sync ID in the box.
The Sync ID is used to identify the target share or partition that will
receive replicated data from the source share or partition. The Sync
ID must be identical to the Sync ID of the target share or partition
on the target system.
The Sync ID must contain no more than 32 characters (NAS share)
or 12 characters (VTL partition) and can contain only alphanumeric
characters, underscores, and hyphens. (An underscore or hyphen
must not be the first character.)
Note: If you are performing Directory/File or Cartridge Based
Replication with a system running a DXi software version
prior to 2.3, you may need to change the Sync ID on the
system running pre-2.3 software to match the above Sync
ID name restrictions.
6 Select the check box for each replication target you want to
replicate the share or partition to. (You must select at least one
target.) When the share or partition is replicated, its data will be
sent to all selected targets.
Note: Directory/File or Cartridge Based Replication will be
configured for all selected targets. You cannot configure
one share or partition for multiple replication types.
7 Click Apply.
Note: After you configure a share or partition for Directory/File or
Cartridge Based Replication, you should synchronize it to
ensure it is in sync with the target share or partition (see
Synchronizing a Share or Partition
Chapter 6: DXi4701 Replication
Replication Send
on page 130).
129