The Tg789Vac V2 Network File Server - Technicolor TG789vac v2 Setup And User Manual

7.1 The TG789vac v2 network file server

Introduction
The network server allows you to share content on your storage device(s) with other devices that are connected to your local
network (mostly computers).
These devices have
Configuration
The network file server is
To change the default settings, proceed as follows:
1 Browse to the TG789vac v2 GUI.
For more information, see
2 On the Toolbox menu, click Content Sharing.
3 In the Navigation
4 Under Network File Server, you can change the following settings:
Server Name:

Enter the name that you want to use for the TG789vac v2 shared content.
 Server Description:
Add a short description for the TG789vac v2 shared content.
 Workgroup:
Enter the same workgroup as used by your computer(s).
Server Enabled:

Select this option to enable the network file server.
5 Click Apply.
6 All users connected to the TG789vac v2 can now access the data stored on the storage device(s) that are connected to
the TG789vac v2.
7 If you want to limit the number of folders that can be accessed, continue with
page 65.
Accessing the shared content on Windows
Proceed as follows:
1 Open Windows Explorer.
2 In the address bar, type two backslashes followed by the server name that you provided (default: \\Technicolor).
If you did not provide a server name, type \\192.168.1.253.
If you made changes to the DHCP settings, the IP address may also have changed. For more information, see
"Getting the IP address of your USB storage device" on page
DMS3-CTC-25-282 v1.0
read and write access
enabled by default and ready for use.
"Accessing the TG789vac v2 GUI" on page
bar, click Configure.
to this USB device(s).
29.
97.
7 Sharing content
"7.4 Working with managed partitions" on
56