Eco Manager - Technicolor TG789vac v2 Setup And User Manual

6.2 ECO manager

Introduction
The TG789vac v2 constantly monitors all the user activity via the TG789vac v2 and uses this information to optimise its
power consumption:
For example:
• The TG789vac v2
lowered clock frequency will result in a lower power consumption of the TG789vac v2.
• Disable the USB port(s)
• Reduce its Ethernet switch functionality to link detection
• Switch its wireless interface to power reduction
Wireless access point power reduction mode
When the TG789vac v2 access point switches to power reduction mode, the access point is switched off and is only switched
on periodically to allow to detect new wireless clients. If new clients are detected the wireless access point is immediately fully
powered again.
The TG789vac v2 will only switch off the access point if there are no devices connected to the access point at that
moment.
Power reduction is enabled by default, but it is possible to disable it via the TG789vac v2 GUI. To configure power reduction:
1 Browse to the TG789vac v2 GUI.
For more information, see
2 On the left menu, click Home Network.
3 The Home Network page appears, Under Wireless. click:
 WLAN to view the settings of the 2.4 GHz access point.
WLAN_5G to view the settings of the 5 GHz access point.

4 In the Navigation
5 Under Configuration:
 Select Power Reduction Enabled to enable power reduction.
 Clear Power Reduction Enabled to disable power reduction.
6 Click Apply.
DMS3-CTC-25-282 v1.0
is able to reduce the clock frequency of its central processor
when they are not used
"Accessing the TG789vac v2 GUI" on page
bar, click Configure.
when there are no devices connected to the Ethernet port.
mode.
29.
6 Saving energy
when there is no or low user activity. This
52