5.0 Maintenance; Introduction; Downloading Software To Wag Using Xfiles Command; Figure 5-1. Zmodem File Transfer Menu - Siemens A53457 Installation & Maintenance

5.0 MAINTENANCE

5.1

INTRODUCTION

There are no adjustments in the WAG. If a unit is suspected of being faulty, it should be replaced.
No field repairs should be attempted. No other periodic field maintenance is required.
Procedures for uploading and downloading files to and from the WAG can be accomplished from
the boot screen or from the terminal ready screen. An example of each method is described in
this section.
5.2

DOWNLOADING SOFTWARE TO WAG USING XFILES COMMAND

The xfiles command is to be used only with the serial interface. If the user
attempts to run this command via Telnet sessions, the file transfer will fail.
1. Type xfiles and then press Enter. The ZMODEM file transfer menu will be displayed.
2. From the ZMODEM file transfer menu, select the applicable software type to download by
choosing the applicable download option (Options 1 through 4).
3. "Waiting to receive ZMODEM <type of file>" is displayed on the file transfer screen.
4. Select "Send file" from the Transfer menu. The Send File pop-up screen will be displayed.
Document No.: COM-00-05-16
Version: C.1
SECTION 5
MAINTENANCE

Figure 5-1. ZMODEM File Transfer Menu

5-1
NOTE
June 2006, Revised June 2014
MAINTENANCE