Operation; Introduction; Table 3-1. Wag Commands - Siemens A53457 Installation & Maintenance

3.0 OPERATION

3.1

INTRODUCTION

This section explains the available commands with respect to the WAG.
Command Shorthand
? ?
Break bre
Command com
Config con
Data dat
log1 log1
log2 log2
Log3 Log3
Ping pin
Project pro
Reqip reqip
Restart res
Revisions rev
Routes rou
Rping rpi
Sconfig sco
Smac sma
Status sta
Sdate sda
Stime sti
Testmode tes
Trace tra
Ttimes ttimes
Tunnel tun
Verbosity ver
Wagreport wagreport
Winkwag win
Xfiles xfi
The WAG serial interface must be in Command mode before the following
commands will work.
Document No.: COM-00-05-16
Version: C.1
SECTION 3
OPERATION

Table 3-1. WAG Commands

Gets a list of keyboard commands.
Breaks to the boot monitor.
Returns the WAG serial interface to command mode from Telnet.
Allows changes to the WAG configuration.
Returns the WAG serial interface to data mode.
Shows the event log.
Clears the log.
Enables/disables event log streaming.
Sends a PING to an IP address.
Shows system level information about the WAG.
Request a new IP address from a DHCP server.
Reboots the WAG.
Displays all WAG software version information.
Shows the route table.
Pings a route ID.
Shows current configuration settings.
Shows MAC addresses in the route table.
Displays status information of system operation.
Sets the current date.
Sets the time of day.
Sets/stops the WAG test mode (0, 1, 2, or 3).
Traces one or more interfaces.
Displays WAG task usage.
Connects RAW serial interface tunnel.
Sends run-time messages out serial interface when unit is in
command mode.
Search for and report other WAGs.
Sends WINK request to a WAG.
Uploads and downloads files.
3-1
Description
NOTE
June 2006, Revised June 2014
OPERATION