Siemens A53457 Installation & Maintenance page 112

OPERATION
Table 3-2 continued
Classification Log Entry
Informational
Received request to
WINK
Informational
ATCS: Multipart *
Informational
BREAK command received
Informational
CONFIG command
received
Informational
Diagnostic verbosity
changed from <x> to
<y>
Informational
Leaving test mode
Informational
Performing factory
test mode
Informational
Performing screen test
mode
Informational
Performing spew test
mode
Informational
RESTART command
received
Informational
Route Add Echelon
<xxx.yyy> type <z> <w>
Informational
Route Add Serial <ATCS
addr>
Document No.: COM-00-05-16
Version: C.1
Description
Indicates the WAG was asked to "wink" its
Health LED.
Means that a large ATCS message was broken
into multiple parts by the WAG before it was
routed.
(* only if verbosity level is greater than 9)
Someone entered the BREAK command from
either the serial interface or from a Telnet
session.
Someone entered the CONFIG command from
either the serial interface or from a Telnet
session.
The logging verbosity level was changed.
Shows the old value and the new value.
The WAG is done with a test.
Someone requested a factory test either from
the serial interface or from a Telnet session.
Someone requested a factory serial port
screen test either from the serial interface or
from a Telnet session.
Someone requested a factory spew test either
from the serial interface or from a Telnet
session.
Someone entered the RESTART command
from either the serial interface or from a
Telnet session.
A new ATCS address of an Echelon device was
added to the WAG routing table. The subnet
and node address are listed with the Foreign
Frame type of the device in addition to the
ATCS address.
XXX = subnet
YYY = node
W = ATCS address
Z = frame type
A new ATCS address of a serial device was
added to the WAG routing table. The entry
shows the ATCS source address.
3-24
June 2006, Revised June 2014