Table of Contents
Advertisement
INSTALLATION AND CONFIGURATION
2.6.20
ATCS Server UDP Port Number
Office devices usually listen for "route request" and other messages on a specific UDP port
number. The default port number is 5361, however it is configuration setting.
To change the ATCS Server UDP Port Number:
1.
On the Second Configuration Menu, select "ATCS Server UDP Port number" to be changed.
The Change ATCS Server UDP Port Number screen appears.
Figure 2-48. Change ATCS Server UDP Port Number Screen
2.
To keep the current ATCS Server UDP Port Number, press ENTER. If not, enter the new port
number and then press ENTER. Entry can be any value from 0 to 65535.
The user will be returned to the Second Configuration Menu.
3.
Prior to exiting the First Configuration Menu, select "Save changes then restart" to save
changes and restart the WAG.
2.6.21
Telnet Port Numbers
Because there are routers, bridges, and hubs that block Telnet port 23 for security reasons, the
"well known" Telnet and Serial Telnet port numbers have been made configuration setting. This
will allow the user to change the numbers to values that are not blocked.
The default values for this function are 23 for the WAG Telnet port and 10023 for the Serial
Telnet port.
To change the Telnet Port Numbers:
1.
On the Second Configuration Menu, select "Telnet Port Numbers" to be changed. The Change
Telnet Port Numbers screen (see Figure 2-49) appears.
Document No.: COM-00-05-16
Version: C.1
2-36
June 2006, Revised June 2014
Advertisement
Table of Contents
Troubleshooting
