CDVI CDV96KP User Manual page 17

Input the master code.
(Default: [ ]+[#] )
16.Setting the code
forTemporary1
Input the setting code.
18+#
(red) (blue)
ON ON
Beep+, Beep
Inputting of code (ex.: 1006)
1~12 digits
1006+#
(red) (blue)
OFF
ON
Beep+
- When the "
*
cancel" key is pressed, the LED lights off, the buzzer beeps, and the system exits the setting mode
- When there isn't any operation in 10s, the LED lights off, the buzzer beeps, and the system exits the setting mode
- When input the correct temporary password to release the door,
the system will clear the temporary password after 60 seconds
automatically.But you should know that the password is valid within
60 seconds after inputing the correct temporary password
- The temporary1 is used to release the first lock,and the temporary
2 is used to release the second lock.
- If the password length exceeds 12 digits, the system will sent out
the sound of "beep,beep,beep,beep",and the digitals you input before
will be cleared at the same time.
- The temporary code can not be set the same as the master code
and user code.
17.Setting the code
forTemporary2
Input the setting code.
19+#
(red) (blue)
ON ON
Beep+, Beep
Inputting of code (ex.: 2011)
1~12 digits
2011+#
(red) (blue)
OFF
ON
Beep+
-15-
(red) (blue)
ON OFF
18.Setting the code
for user group1
20~59
Input the setting code.
(ex.:21)
21+#
(red) (blue)
ON ON
Beep+, Beep
Inputting of code (ex.: 2011)
1~12 digits
2011+#
(red) (blue)
ON OFF
Beep+
- The user code group1 is used to release the first lock,and the user code
group2 is used to release the second lock.
- The user code group1 and user code code group2 can contain 40
group passwords
- If the password length exceeds 12 digits, the system will sent out the
sound of "beep,beep,beep,beep",and the digitals you input before will
be cleared at the same time.
- The user code can not be set the same as the master code and
temporary code.
NOTE: User group 2 operates part No. CDV-RLC if connected.
Beep+, Beep
19.Setting the code
for user group2
60~99
Input the setting code.
(ex.:60)
60+#
(red) (blue)
ON ON
Beep+, Beep
Inputting of code (ex.: 2012)
1~12 digits
2012+#
(red) (blue)
ON OFF
Beep
(red) (blue)
OFF
OFF
Beep, Beep+