Princeton Instruments PI-MAX4 Manual page 201

Chapter 13
d.
e.
f.
g.
Configure the
4.
Verify that the
5.
and that
expander.
When the experiment is ready, click on the
6.
PI-MAX4: 1024i-RF and RF Modulation
To enable trigger outputs on the AUX I/O cable's
connectors, click on the
SyncMASTER2
When SyncMASTER is enabled, the output of the
driven at the frequency specified by the
The frequency is also specified by the
SyncMASTER2
, but can be delayed from 0 ns to 6,553,500 ns, in 100 ns increments, by
Frequency
configuring
SyncMASTER
NOTE:
The blue SyncMASTER1 and black SyncMASTER2 cables
are used to differentiate these output signals when they are
shown on the SuperSYNCHRO timing diagram.
To drive an RF amplifier via the
PI-MAX4: 1024i-RF, click the
Configure the following RF Output parameters as required:
• Output Frequency
• Output Amplitude
The port on the back of the camera must be connected to a
User RF Output
standard RF 50 Ω load.
Configure the following parameters:
• Modulation Duration
• Modulation Frequency
• Modulation Starting Phase
Configure the following AUX Output Trigger parameters as required:
;
• AUX Output Delay
.
• AUX Output Width
Modulation Ending Phase
switch on the rear of the PI-MAX4: 1024i-RF is turned
I.I.T. Power
has been checked on the
Enable Intensifier
SyncMASTER1
SyncMASTER: ON
Internal Trigger Frequency
appropriately.
Delay
2
connector on the back of the
User RF Out
User RF Output ON
;
;
.
.
Common Acquisition Settings
button.
Acquire
and
button.
SyncMASTER1 connector is
.
Internal Trigger
button.
201
ON