Figure 6-15: Typical Supersynchro Timing Expander - Princeton Instruments PI-MAX4 Manual

114

Figure 6-15: Typical SuperSYNCHRO Timing Expander

Perform the following procedure to configure gate timing parameters as indicated:
a. Mode: Sequential
b.
®
PI-MAX
If using a Gen II intensifier, deselect
Perform the following procedure to configure the pulse sequence:
• Click on the Frames to Save
acquired (e.g.,
41
Configure the
• Starting Gate Width
Because this experiment requires a fixed gate width, these values will be
the same.
• Starting Gate Delay
• Ending Gate Delay
Click on the
• On-CCD Accumulations
On-CCD Accumulations
4 System Manual
Enable Bracket Pulsing
hyperlink. Enter the number of frames to be
for this experiment.)
and
Ending Gate Width

: ;
1 s

: ;
201 s
hyperlink. Enter the number of
per frame (e.g.,
for this experiment.
.
for this experiment.)
1
Issue 9