Princeton Instruments PI-MAX4 Manual page 199

Chapter 13
3. On the
External
trigger edge for the trigger pulse being used.
Internal
on the
a.
b.
c.
d.
e.
f.
g.
Verify that the
4.
position, and
Settings
When the experiment is ready, click on the
5.
PI-MAX4: 1024i-RF and RF Modulation
Trigger expander, select
: Verify the trigger characteristics on the
: Perform the following procedure to configure the
SuperSYNCHRO Timing
From the pull-down menu, select
Mode
Use the hyperlinks at the top of the
changes to:
• Intensifier Settings
;
• Trigger Settings
• Phosphor Decay Delay
;
• Frames to Save
.
• Readout Mode
Configure the
Internal Trigger Frequency
To enable trigger outputs on the AUX I/O cable's
connectors, click on the
SyncMASTER2
When is enabled, the output of the
SyncMASTER
driven at the frequency specified by the
The frequency is also specified by the
SyncMASTER2
, but can be delayed from 0 ns to 6,553,500 ns, in 100 ns increments, by
Frequency
configuring
SyncMASTER
NOTE:
The blue SyncMASTER1 and black SyncMASTER2 cables
are used to differentiate these output signals when they are
shown on the SuperSYNCHRO timing diagram.
To drive an RF amplifier via the
PI-MAX4: 1024i-RF, click the
Configure the following RF Output parameters as required:
• Output Frequency
• Output Amplitude
The port on the back of the camera must be connected to a
User RF Output
standard RF 50 Ω load.
Configure the following parameters:
• Modulation Duration
• Modulation Frequency
.
• Modulation Phase
Configure the following AUX Output Trigger parameters as required:
;
• AUX Output Delay
.
• AUX Output Width
switch on the rear of the PI-MAX4: 1024i-RF is in the
I.I.T. Power
Enable Intensifier
expander.
Internal or External
Trigger
expander:
Repetitive
SuperSYNCHRO Timing
;
;
.
SyncMASTER: ON
Internal Trigger Frequency
appropriately.
Delay
2
connector on the back of the
User RF Out
User RF Output ON
;
;
has been checked on the
button.
Acquire
triggering.
expander match the active
parameters
Internal Trigger
.
expander to make any
and
SyncMASTER1
button.
connector is
SyncMASTER1
.
Internal Trigger
button.
Common Acquisition
199
ON