Figure 7-19: Typical Supersynchro Dialog: Trigger Out Tab - Princeton Instruments PI-MAX4 Manual

144
e.

Figure 7-19: Typical SuperSYNCHRO Dialog: Trigger Out Tab

f.
®
PI-MAX
Click on the
Trigger Out
• SyncMASTER Trigger Out
When (i.e., checked,) the frequency of the
Enabled
is the same as the frequency of the
page 141.
• SyncMASTER2 Delay from SyncMASTER1
The output of the
SyncMASTER1
configured so that the leading and trailing edges
a specified time AFTER the corresponding edges of
Parameters
• Auxiliary
When using the
Aux Out
configure the following parameters:
Width
—
Specifies the width of the desired
depending on the specific equipment being controlled.
Delay
—
Specifies the delay between the start of
the
Aux Out
See Figure 7-19.
Click to configure all SuperSYNCHRO parameters and dismiss the dialog.
OK
4 System Manual
tab to configure the following parameters:
Trigger In
signal is identical to that of the
SyncMASTER2
output. However, a delay, in microseconds, may be
signal to trigger an external piece of equipment,
Aux Out
trigger pulse.
SyncMASTER1
signal. Refer to step 13.b on
: measured in µsec.
SyncMASTER2 will occur
SyncMASTER1
trigger pulse. This will vary
SyncMASTER1 and the start of
4411-0139_0059
Issue 9
output
.