Figure 7-18: Typical View Width/Delay Sequence Dialog - Princeton Instruments PI-MAX4 Manual

Chapter 7

Figure 7-18: Typical View Width/Delay Sequence Dialog

WinX and Gated Operation
Configure the following
• Number of Spectra
• Increment Type
• Gate Width Start
This is the desired initial Gate Width.
Both numeric value (e.g.,
configured.
• Gate Width End
This is the desired ending Gate Width.
Both numeric value (e.g.,
configured.
NOTE:
In this example, a fixed gate width experiment is being
configured. Therefore, the starting and ending Gate Widths
will be the same.
• Gate Delay Start
This is the desired initial Gate Delay.
Both numeric value (e.g.,
configured.
• Gate Delay End
This is the desired ending Gate Delay.
Both numeric value (e.g.,
configured.
• On-CCD Accumulations: Gates Per Exposure
NOTE:
To examine the gate delay for each acquired spectra, click on
View Width/Delay Sequence
Click when done.
Close
Sequential Gating parameters:
to be acquired (e.g., 41);
: [radio button]
Fixed
,) and an associated unit (e.g.,
5
,) and an associated unit (e.g.,
5
,) and an associated unit (e.g.,
1
,) and an associated unit (e.g.,
201
. See Figure 7-18.
143
,) must be
µsec
,) must be
µsec
,) must be
µsec
,) must be
µsec
: (e.g., .)
1
4411-0139_0058