Loading Paper Into The Printer - Interacoustics OtoRead Operation Manual

Return the cradle to right side up. The end of the connector cable
should be plugged firmly into the inlet at the rear of the printer. The
fat side on the connector (look for arrow) goes to the bottom of the
printer. Finally, plug the appropriate ends of the power cord into the
power adapter and an outlet.
To turn the printer on, press the button on the front of the printer. The
printer indicator light will flash green briefly and then continue
flashing orange to indicate it is ready to receive data from the
OtoRead unit. The printer will automatically power off after one minute
of inactivity.
Figure 1

Loading Paper into the Printer

Open the lid by pushing on the sides, insert paper roll as shown, and
close the lid.
Figure 2
OtoRead Screener Basic Functions Page 13