Pairing The Wireless Printer To Otoread - Interacoustics OtoRead Instructions For Use Manual

2.7 Installing the wireless thermal printer
The OtoRead communicates with the thermal printer using a wireless connection protocol. Use only the
TM
recommended label printer provided with the equipment.
Refer to the recommended thermal printer's Instructions for Use for initial setup and installation of the battery
and paper.
2.7.1

Pairing the wireless printer to OtoRead

Pairing with the instrument is necessary before wireless printing is possible.
Pairing process:
1. Power on the printer.
2. Power on the OtoRead
3. From the Main Menu, press CHANGE (
4. From the Protocol Menu, press SETUP (
5. From the Date Screen, hold down the
turns off.
6. You are now at the NEW WL menu and can press LEFT or
7. Wait for the device to find the printer (ensure it is switched on) and then press PAIR (
8. The printer is now paired to your device.
3
Note: Do not have several printers powered on and within range while searching.
It is possible to pair up to 8 instruments with one printer. If more instruments are paired, the oldest will be
deleted.
2.8 OtoRead TM Module & Auto Print software
The OtoRead can be used in conjunction with the OtoRead
TM
viewing, printing and managing patient information. For further information about the software, refer to the
OtoRead Module & Auto Print Instructions for Use.
TM
D-0116684-B – 2020/03
OtoRead™ - Instructions for Use - US
by pressing the
TM
DOWN key).
DOWN key).
DOWN key for a few seonds until the green 'READY' LED
4 5
TM
DOWN key.
RIGHT key to search for the printer.
6
Module & Auto Print software for storing,
TM
DOWN key).
7 8
Page 17