Probe Tip Replacement - Interacoustics OtoRead Operation Manual

Figure 5
To replace the probe tip, squeeze the tabs as shown in the picture
Figure 7. The tabs should audibly snap off the probe assembly. Pull
the probe tip directly off the probe and discard it.
Figure 7
Obtain a replacement probe tip and orient the tip as shown in the
picture Figure 9. The probe tip will only fit on one way; be careful not
to force the tip in place. Push the tip directly down onto the probe.
Once the probe tip is in place on the probe, push firmly downward on
the top of the tabs one at a time until a click is heard. Tug lightly on
the probe tip to verify that the tip is securely attached.
NOTE: If the probe tip is not inserted completely, the OtoRead
will not perform a test.
OtoRead Screener

Probe Tip Replacement

Figure 8
Basic Functions
Figure 6
Figure 9 Figure 10
Page 16