Horizontal Stabilizer Installation - Freewing A-6E Intruder User Manual

Horizontal Stabilizer Installation

A. Screws (PT3x5mm 2pcs)
Refer to the diagrams on the right
1. Ensure that the flat points of the
"Elevator rotation shaft" are aligned
with the screws that anchor the
Horizontal Stabilizers. If they aren't
aligned, the surfaces will not be
securely anchored and there is a
possibility of them coming loose
during flight.
2. Connect the rudder servo cable to
the extension cable in the fuselage.
3. Slide the Vertical Stabilizer into the
rear of the fuselage and insert the
screw into the bottom of the
fuselage and tighten it to anchor the
Vertical Stabilizer.
4. Place the foam cover over the
fuselage anchor port and secure it
with the 3 screws. Note the plastic
hard points that the screws feed
into.
&.
Note:
we have installed all the servo boxes
in the aircraft, when pilots remove the servo,
not damage the foam surface. If you need to
will
replace servo, please purchase Freewing
servo ,or refer to the following drawing to
choose the correct size servo.
"::F� �
3 3 3 3
3 3 3 3
-1::::::=----;;.ir-i'I
0111 1 Oi
A-BE Intruder
Item No.: FJ2041
Version No.: FJ2041-VD1
( PT3x5m m ) ( 2pc s )
Rudder push rod size
it
�67.Bmm�
(2.67 in)
Pushrod diameter: 01.2mm
Elevator push rod size(1)
� 60mm �
(2.36 in)
Pushrod diameter: 0 1.2mm
Elevator push rod size(2)
r::==9= 0 mm====Wlll
(3.54 in)
Pushrod diameter: 01.2mm
�----\- -- ->;
- -- -
--'
Rudder push rod mounting hole
t.
2
3· ·--·--·0 ·•··••.,0 t;,,'
�--". _:;;; �t===="'
4 ..... @
Elevator push rod mounting hole(1)
Elevator push rod mounting hole(2)
1·
,
2 - -
-4-
it::::;;';'-