Servo Introduction; Battery Installation - Freewing A-6E Intruder User Manual

Servo Introduction

2000 µs(_
:
A servo or reversed servo is defined as follows: When the
servo input signal changes from 1000ųs to 2000ųs, if the
servo arm rotates clockwise, it's a positive servo.
rotates counter clockwise, it's a reversed servo.
If you decide to purchase another brand of servo,
use the following list to ensure the servo has the
correct dimensions and cable length.
Servo No.
Servo inst alling position
Nose gear steering servo
1
Aileron servo (Left) 2
Aileron servo (Right) 3
4
Flap servo (Left)
5
Flap servo (Right)
6
Elevator servo (Left)
7
Elevator servo (Right)
8
Rudder servo

Battery Installation

Battery hatch
To remove the battery hatch, pull up on the tape as shown in
the diagram. Place the battery on the battery mount and
secure it using the Velcro straps. Check your CG. Ensure
that the radio is turned on and that throttle is in the lowest
position. Engage the kill switch if one is assigned.
A-BE Intruder
Item No.: FJ2041
Version No.: FJ2041-VD1
:
I
If it )
. , . . /
.. /
Servo
Pos./Rev.
Cable Length
100mm
Positive
450mm
Positive
450mm
Positive
Positive 300mm
Reverse
300mm
250mm
Positive
300mm
Positive
Reverse
200mm
to remove
Servo connection instruction
1.Use Y-harness to connect the No.1 and No.8 servos.
2.Use Y-harness to connect the No.2 and No.3 servos.
3.Use Y-harness to connect the No.4 and No.5 servos.
4.Use Y-harness to connect the No.6 and No. 7 servos.
Battery hatch size:
-
Our standard recommended batteries are:
45 14.SV 4000mAh 35C
or
65 22.2V 3700mAh 35C
The recommended battery capacity and discharge rate is :
4514.8V 3200mAh ~ 4S 14.BV 4500mAh
iiiiiiii
65 22.2V 3200mAh ~ 65 22.2V 4500mAh
Discharge rate of C � 25C
Different battery weights may affect the CG. Be aware of this
and adjust to battery position to attain the correct CG.
-9-
EN
190x5Qx4 7mm