Main Wing Installation; Drop Tank And Bombs Installation - Freewing A-6E Intruder User Manual

Main Wing Installation

1. Insert the Carbon fiber rod into the
fuselage.
2. Slide the port and starboard wings
onto the Carbon fiber rods.
3. Use the 4 screws to anchor the
wings to the fuselage.
Wing Servo Installation
A-Screws
(PWA1.7'5mm 2 pcs)
B - 9g servo cover
C - 9g servo boxes
D - Control horns (2pcs)
E - Push rods (2 pcs)
F - Trough
1.Use a servo tester or radio to center the
servo.
2.Apply the glue to the servo bays and the
control surfaces to attach the "9g servo
boxes(C)" and "Control horns (D)" to the wings.
3.Place the servo in the" 9g servo box (C)", and
press the servo cable into the "Trough (F)",
then place the"9g servo cover (B)" over the
servo and secure it with 2 "Screws(A)".
4. Use "Push rods(E)" to connect the
servo arms and "Control horns (D)".
�
23.8mm
23.8mm -
Drop Tanks And Bombs Installation
1. Apply glue to attach the drop tank pylons
to the main wing.
2. After the glue sets, the drop tanks are
attached to the pylons magnetically.
3. Use glue to attach the optional bomb
pylons to the wings.
4. After the glue sets, the bombs attach to
the pylons magnetically.
(The kit does not include bombs. If you
wish to purchase them separately,
contact your local distributor)
A-BE Intruder
Item No.: FJ2041
Version No.: FJ2041-VD1
(PWA3<20mm) (4pcs)
�t
01111 Di
Aileron push rod size
� 67 .Bmm �
Pushrod diameter: 0 1.2mm
Flap pushrod size
we have installed all the servo
&,Note:
boxes in the aircraft so when pilots remove
a servo, it will not damage the foam surface.
If you need to replace a servo, purchase
�55mm�
Freewing servo ,or refer to the following
drawing to choose the correct size.
Pushrod diameter: 0 1.2mm
Aileron pushrod mounting hole
[ i �t�•����:
(2.67 in)
4
Flap pushrod mounting hole
(2.17 in)
. . .. . . .. . . . . . 1