Battery Installation - Freewing MIG-21 FISHBED User Manual

3-Axis Gyro Introduction and Use
Use 4 screws to secure the gyro onto the board at the front of the
battery compartment. Make sure the gyro decal is facing the nose cone
when installing.
( . )
Screws PA2 3x8mm

Battery Installation

Battery
Battery tray
Before connecting the battery to the ESC, please
switch on the transmitter power and make sure the
throttle stick is in the lowest position. Engage the kill
switch if you have one assigned.
9
Hatch
Velcro
The gyro was factory tested and set up at default sensitivity. You can
fine tune it according to your preference and flight conditions. Refer to
the photo to reset factory default settings.
Install the battery to the front of fuselage,
and use the velcro strap to secure it.
Battery Hatch size : L=280 , W=66 , H=70 (mm)
The recommended battery size and
discharge rate is:
6S 22.2V 4000mAh~6S 22.2 5500mAh
Discharge rate of C
35C
MIG-21MF FISHBED
Item No.:FJ210