Fuselage Assembly; Elevator Servo Installation; Rudder Servo Installation - Freewing A-6E Intruder User Manual

Fuselage Assembly

Refer to the photo on the right
for proper glue points.
Once the glue has set for approximately
90 seconds, join the two pieces then pull
them apart, creating 'strings' of glue.
Repeat 3 times then press the two
pieces together for the final time, this will
ensure maximum strength at the glued
point.

Elevator Servo Installation

A- Screws
(PWA1 .7x5mm 3pcs)
B - Elevator servo cover
C - Elevator servo plastic hard point
D - Elevator rotation shaft
E - Elevator rotating arm
F - Screws
(PT3'5mm 2pcs)
1. Use a radio or servo tester to center the
servo.
2. Apply the glue to mount the
"Elevator servo plastic hard point(C)" on
the white colored position as shown in the
photo on the right.
3. Place the servo onto the "Elevator servo
plastic hard point(C)", then place the
"Elevator servo cover(B)" over the servo
and use the 4 screws to secure it.
4. lnsert the "Elevator rotation shaft(D)" in
the "Elevator rotating arm (E)" and
secure it with 2 "Screws(F)".
5. Use push rod to connect the servo arm
to the "Elevator rotating arm(E)".

Rudder Servo Installation

A- Screws (PWA1.1, 5mm)
B - 9g servo cover
C - 9g servo box
D - Surface control horn
E - Rudder push rod
F - Trough
Refer to the photo on the right
1. Use a radio or servo tester to center the
servo.
2. Apply glue to the servo bay and install
the "9g servo box(C)".
3. Apply glue to the rudder and install the
"Surface control horn(D)".
4. Place the servo in "9g servo
box(C)" and press the wire into the
"Trough(F)".
5. Place the "9g servo cover(B)" over the
servo and secure it using the 2
"Screws(A)".
6. Feed the open end of the
"Rudder pushrod(E)" into the servo and
snap the clevis onto the
"Surface control horn(D)"
A-BE Intruder
Item No.: FJ2041
Version No.: FJ2041-VD1
t
B�\.
-3-
EN
I
E