Pnp Lnstallation Instructions; Traction Steel Wire Use Instruction; Install Horizontal Stabilizer; Install Vertical Stabilizer - Freewing BAe HAWK User Manual

PNP lnstallation Instructions

Traction steel wire use instruction

To minimize servo connections, the Elevator and Rudder servos' wires each reach from the servo itself directly to
the receiver. A rigid steel wire hook is included in the box to allow you to pull the servo wires through the model's
internal fuselage.

Install Horizontal Stabilizer

As shown in the photo below:
1.Insert the elevator servo cable into the wire channel in the
rear portion of the fuselage.
2.Use traction wire to pull the elevator servo cable
to the battery compartment.
3.Install the elevator on the rear fuselage and secure
with 4pcs screws (PA2.6x10).
A-Elevator servo cable
B-Elevator wire channel
C-Elevator
D-Screw
(PA2.6x10 4pcs)
Step 3

Install Vertical Stabilizer

As shown in the photo below:
1.Insert the rudder servo cable through plastic mount;
2.Use traction wire to pull the rudder servo cable
to the battery compartment.
3.Install the rudder on the rear fuselage and secure
with 4pcs screws (KA2.6x8).
A- Rudder servo cable
B- Plastic mount
C- Rudder
D- Screw
(KA2.6x8 4pcs)
Traction steel wire
Battery compartment
Step 2
3
Traction steel wire
Battery compartment
Step 2
C
Rudder servo cable
D
A
A
D
B
Step
1
C
Elevator servo cable
Step 1
B
Step 3
BAe HAWK
Item No.:FJ214