Installing The Water Pump And Shift Rod - Yamaha 250GETO Service Manual

4. Install the propeller shaft housing bolts
4, and then tighten the bolts to the spec-
ified torque.
5. Install the ring 5 and bolts 6.
NOTE:
Apply LOCTITE 271 to the drive shaft hous-
ing bolts 4 and LOCTITE 572 to the bolts 6
before installation.
Propeller shaft housing bolt 4 :
30 N·m (3.0 kgf·m, 22.1 ft·lb)
Bolt 6 :
18 N·m (1.8 kgf·m, 13.3 ft·lb)
Installing the water pump and shift
rod
1. Install the shift rod assembly 1 and seal
2.
3
1
2
Shift rod cover bolt 3:
8 N·m (0.8 kgf·m, 5.9 ft·lb)
6S35H11
Drive shaft and lower case (counter rotation model)
6
5
4
6S360120
6S360129
NOTE:
9 Check the gear shift to the neutral position,
when installing the shift rod.
9 After assembling the lower unit, check that
the shift rod operates smoothly, and check
that the drive shaft and propeller shaft
rotates smoothly.
2. Install a new gasket 4, the outer plate
cartridge 5, and dowels 6.
5
4
6
3. Install the Woodruff key 7 into the drive
shaft.
4. Align the groove in the impeller 8 with
the Woodruff key 7, and then install the
impeller onto the drive shaft.
6
6S360128
8
7
69D60235
6-50
1
2
3
4
5
6
7
8
9