Installing The Water Pump And Shift Rod - Yamaha F50A Service Manual

Installing the water pump and shift
rod
1. Install the shift rod assembly 1.
NOTE:
Install the shift rod assembly into the lower
case, turn it clockwise 90° a, and then push
it down b to connect it to the shift slider 2.
2. Install the new oil seals into the oil seal
housing as shown.
62Y3A11
Water pump and shift rod (T50/FT50B, FT50C)
È For USA and Canada
É For worldwide
Bearing housing oil seal installer 3:
YB-06269
Driver handle 4: YB-06071
Needle bearing attachment 5:
90890-06610
Driver rod L3 6: 90890-06652
3. Install the new O-ring 7.
4. Install the new gasket 8, oil seal housing
9, new gasket 0, and outer plate car-
tridge A.
5. Install the Woodruff key into the drive
shaft.
1
2
3
4
5
6
7
8
I
6-48