Adjusting The Trim Sensor - Yamaha 250GETO Service Manual

2. Install the PTT unit mount bolts 2 onto
both clamp brackets together with the
PTT unit 3, and then tighten them.
3. Install the tilt ram upper end into the swiv-
el bracket with the shaft 4 and circlip 5.
4. Tighten the self-locking nut 6 to the
specified torque.
Self-locking nut 6:
22 N·m (2.2 kgf·m, 16.2 ft·lb)
5. Install the anode 7.
6. Pass the PTT motor lead and trim sensor
lead through the hole of the starboard
clamp bracket.
7. Fasten the PTT motor lead and trim sen-
sor lead with the lockties 8.
5
4
2
3
7
6S35H11
8. Inject grease into all grease nipples until

Adjusting the trim sensor

1
1. Fully tilt the outboard motor up, and then
6
8
w
After tilting up the outboard motor, be
sure to support it with the tilt stop lever.
Otherwise, the outboard motor could sud-
6S370030
denly lower if the PTT unit should lose
fluid pressure.
Clamp bracket and swivel bracket
grease comes out from the bushings a.
support it with the tilt stop lever 1.
1
2
3
4
S69J7145
5
6
1
7
S60V3310
8
9
7-20