Checking the crank position sensor
air gap
1. Remove the flywheel magnet cover.
2. Measure the crank position sensor air
gap a. Adjust if out of specification.
a
Crank position sensor air gap:
0.5 – 1.5 mm (0.02 – 0.06 in)
3. Loosen the screws 1 and adjust the
crank position sensor air gap.
1
4. Tighten the screws, and then check the
crank position sensor air gap.
Checking the engine temperature
sensor
1. Remove the junction box cover.
2. Disconnect the engine temperature sen-
sor coupler.
3. Turn the engine start switch to ON.
6S35H11
Ignition and ignition control system
4. Measure the input voltage at the engine
temperature sensor coupler (engine tem-
perature sensor side). Check the wiring
harness if less than specification.
6S380110
5. Connect the digital circuit tester to the
engine temperature sensor coupler a
and CDI unit coupler b (wiring harness
end).
6. Check the continuity. Replace the wiring
harness if no continuity.
6S380120
DCV
Engine temperature sensor input
voltage: (reference)
Black/yellow (B/Y) 1 –
Black/yellow (B/Y) 2
5 V
a
b
1
2
3
6S380126
4
5
6
7
8
1
2
6S380125
9
8-12