Yamaha 250GETO Service Manual page 229

17. Place the PTT unit in an upright position.
18. Remove the reservoir cap 4, and then
check the fluid level in the reservoir.
w
Make sure that the trim and tilt rams are
fully extended when removing the reser-
voir cap, otherwise fluid can spurt out
from the unit due to internal pressure.
NOTE:
If the fluid is at the correct level, the fluid
should overflow out of the filler hole when the
cap is removed.
19. If necessary, add sufficient fluid of the
recommended type to the correct level.
4
Recommended PTT fluid:
ATF Dexron 2
20. Install the new O-ring and reservoir cap
4, then tighten it to the specified torque.
Reservoir cap 4:
7 N·m (0.7 kgf·m, 5.2 ft·lb)
6S35H11
6S370115
PTT unit
1
2
3
4
5
6
7
8
9
7-26