Yamaha 250GETO Service Manual page 158

LOWR
2. Set the gear shift to the neutral position
at the lower unit. Make sure that the shift
rod is in the neutral position using a spe-
cial service tool.
Shift rod push arm:
90890-06052
3. Install the 2 dowels 1 into the lower unit.
4. Install the lower unit into the upper case,
and then tighten the lower case mount
bolts 2 to the specified torque.
5. Install the trim tab 3 to its original posi-
tion, and then tighten the trim tab bolt 4
to the specified torque.
1
2
Lower case mount bolt 2:
47 N·m (4.7 kgf·m, 34.7 ft·lb)
Trim tab bolt 4:
42 N·m (4.2 kgf·m, 31.0 ft·lb)
6-21
Lower unit
69D60036
5
4
1
3
2
2
6S360145
6. Install the grommet 5.
7. Install the propeller and propeller nut 6,
and then temporarily tighten the nut.
Place a block of wood between the anti-
cavitation plate and propeller to keep the
propeller from turning, and then tighten
the nut to the specified torque.
w
9 Do not hold the propeller with your
hands when loosening or tightening it.
9 Be sure to disconnect the battery cables
from the battery and remove the lock
plate from the engine stop lanyard
switch.
9 Put a block of wood between the anti-
cavitation plate and propeller to keep the
propeller from turning.
NOTE:
If the grooves in the propeller nut 6 do not
align with the cotter pin hole, tighten the nut
until they are aligned.
6
6F660420
6S35H11