Installing The Water Pump And Shift Rod - Yamaha F50F Service Manual

LOWR
3. Install the propeller shaft housing assem-
bly 4 into the lower case, and then
install the straight key 5, claw washer
6, and ring nut 7.
4. Tighten the ring nut to the specified
torque.
NOTE:
• To secure the ring nut, bend one tab a of
the claw washer into a slot in the ring nut.
• Bend all other tabs toward the propeller
shaft housing assembly.
Ring nut wrench 3 8: 90890-06511
Ring nut wrench extension 9:
90890-06513
Ring nut 7:
103 N·m (10.3 kgf·m, 76.0 ft·lb)
Installing the water pump and shift
rod
1. Install the shift rod assembly 1.
6-43
Lower unit
NOTE:
Install the shift rod assembly into the lower
case, turn it clockwise 90° a, and then push
it down b to connect it to the shift slider 2.
2. Install new oil seals into the oil seal hous-
ing as shown.
NOTE:
Install an oil seal halfway into the oil seal
housing, then the other oil seal.
Needle bearing attachment 3:
90890-06610
Driver rod L3 4: 90890-06652
Depth c:
3.5–4.5 mm (0.14–0.18 in)
6C13G11