Table of Contents
Advertisement
3.2
Transmitter, Sensing Probe
3.2.1
Installation EE244
Installation of fixed sensing probe:
The transmitter should be mounted in such a way that the probe points downwards.
Ø6
Ø13
(0,5")
Installation a remote sensing probe:
The sensing probes can be installed remotely up to 10m (33ft).
For pluggable sensor cables (2m, 5m, and 10m) and radiation shields, see chapter 8, Replacement
parts / Accessories.
During installation it is recommended to create a water-drip-off-bend in the cable.
Ø13
(0,5")
Installation of the housing:
1. Drill the mounting holes according to the drill template (see sketch). There is a special mounting kit
available for the installation on DIN- rail (see chapter 8. Replacement parts / Accessories).
2. Mount the bottom part of the housing with 4 screws; less than 4.2mm in diameter
(not in the scope of supply).
3. Connect the transmitter (see chapter 3.2.2 Electrical Connections).
4. Install the cover with 4 screws (in the scope of supply).
Operating manual Series EE240 Wireless sensor
(0.2")
Ø12
(0.4")
9
Advertisement
Table of Contents
