Table of Contents
Advertisement
3.1.4. Webserver
The EE242 can be set up with any desired configuration by means of the webserver;
as a result one has full control of the entire network.
The base station of the series E240 does not have a data logger.
For a detailed technical description, see chapter „Configuration Software".
3.1.5. Network Reset
To reset the system to the default factory settings, the push-button "Connect" should be
pressed for 10 seconds.
EE241: the wireless connection with the transmitter will be cancelled.
EE242: all wireless connections (with transmitters and routers) will be cancelled.
All settings will reset to the default factory settings, IP address of the base station,
password of the web server, etc.
3.2
Transmitter, Sensing Probe
3.2.1. Installation
∅13
∅6 (0.2")
(0.5")
∅12 (0.4")
∅13 (0.5")
Installation of a transmitter with a fixed sensing probe:
The transmitter should be mounted in
such a way that the probe points
downwards.
Installation of a transmitter with a remote
sensing probe:
The sensing probes can be installed remotely
up to 10m (33ft).
For pluggable sensor cables (2m, 5m, and
10m) and radiation shields, see chapter 8,
Replacement parts / Accessories.
During installation it is recommended to
create a water-drip-off-bend in the cable.
Installation of the housing:
1. Drill the mounting holes according to the drill
template (see sketch). There is a special
mounting kit available for the installation on
DIN- rail (see chapter 8. Replacement parts /
Accessories).
2. Mount the bottom part of the housing with 4
screws; less than 4.2mm in diameter (not in
the scope of supply).
3. Connect the transmitter (see chapter 3.2.2
Electrical Connections).
4. Install the cover with 4 screws (in the scope
of supply).
9
Advertisement
Table of Contents
