Sae Washer - LifeFitness CSHAA Assembly Instructions Manual

Club series hip ab / adductor
Table of Contents

Advertisement

13
FIRST HOLE
3/8 X 2-1/4" 19
4
12
STEP 21:
The following are the adjustment steps for the RIGHT and LEFT PIVOT ARMS (4 & 5). Please follow them in order and carefully.
RIGHT PIVOT ARM (4) ASSEMBLY: (THIS MUST BE DONE FIRST)
SECURELY assemble ROD END BEARING (50) on the RIGHT PIVOT ARM (4) to the PIVOT LINK (12) using two RH CAPS (48),
one 3/8 X 2-1/4" BOLT (19), two 3/8" SAE WASHERS (27), two 3/8" RH WASHERS (28), one 3/8 X 1/4" SPACER (31), and one 3/8"
LOW HEIGHT LOCK NUT (25) as shown in FIGURE 21. (Note: DO NOT assemble the RH CAPS until all the adjustments have
been made.)
Lift HANDLE (13) on the RIGHT PIVOT ARM (4) and adjust it forward to the first hole position.
For correct alignment of the RIGHT PIVOT ARM (4), the END of the FOOT SUPPORT (14) should be center of the SEAT PAD (44).
(SEE TOP VIEW)
IF NOT CENTERED: Disassemble the ROD END BEARING (50) from the PIVOT LINK (12) and rotate BEARING counter-clock-
wise to move PIVOT ARM forward, or clockwise to move PIVOT ARM back. (turn one complete revolution per time then reas-
semble, and check) Once the PIVOT ARM is centered, tighten bolt and assemble the two RH CAPS (48). Proceed to LEFT PIVOT
ARM (5) assembly
IF CENTERED: Assemble the two RH CAPS (48), and proceed to LEFT PIVOT ARM assembly.
14
TOP VIEW
14
48
27
28
31
50
25
4
44
19
44
FIGURE 21

Advertisement

Table of Contents
loading

Table of Contents