Table of Contents
Advertisement
4
58
FIGURE 7
STEP 7:
• Slide one PILLOW BLOCK (33) over the shaft on the RIGHT PIVOT ARM (4.
• LOOSELY assemble one 4-1/2" PULLEY (10) to the middle rectangular tube on the RIGHT PIVOT ARM (4) using one 3/8 X 2-
3/4" BOLT (20), one CABLE CLIP (53) and one 3/8" LOW HEIGHT LOCK NUT (25) as shown in FIGURE 7.
• LOOSELY assemble one 4-1/2" PULLEY (10) to the bottom rectangular tube on the RIGHT PIVOT ARM (4) using one 3/8 X 4-
1/2" BOLT (52), one CABLE CLIP (53) and one 3/8" LOW HEIGHT LOCK NUT (25) as shown in FIGURE 7.
• Assemble two 1 X 1" GLIDES (11) to the top of the L-brackets on the RIGHT PIVOT ARM (4) as shown in FIGURE 7.
1/2
0
4d
57
10
3/8 X 4-1/2" 52
1/2
1/2
1
2
33
25
4b
1/2
3
4
8
LIGHTLY
TIGHTEN!
11
53
20 3/8 X 2-3/4"
1/2
1/2
5
4a
4c
6
Advertisement
Table of Contents
