Table of Contents
Advertisement
STEP 18:
•
Assemble the ROD END BEARINGS (50) to the 3/8"
THREADED RODS (49) so that a 2-7/8" gap exists
between the end of the ROD END BEARINGS (5) as
shown in FIGURE 18. (NOTE:Make sure each
THREADED ROD (49) is screwed into each ROD END
(50) equally.)
48
3/8 X 3-1/4" 22
27
28
31
25
FIGURE 19
STEP 19:
• SECURELY assemble the ROD END BEARINGS (50) to the RIGHT PIVOT ARM (4) using two RH CAPS (48), one 3/8 X 3-1/4" BOLT
(22), two 3/8" SAE WASHERS (27), two 3/8" RH WASHERS (28), one 3/8 X 1/4" SPACER (31) and one 3/8" LOW HEIGHT LOCK NUTS
(25) as shown in FIGURE 19.
• SECURELY assemble the ROD END BEARINGS (50) to the LEFT PIVOT ARM (5) using two RH CAPS (48), one 3/8 X 3-1/4" BOLT (22),
two 3/8" SAE WASHERS (27), two 3/8" RH WASHERS (28), one 3/8 X 1/4" SPACER (31) and one 3/8" LOW HEIGHT LOCK NUTS (25)
as shown in FIGURE 19.
FIGURE 18
50
4
10X
49
10X
2-7/8"
5
17
50
(NOTE: About 10 complete
revolutions each end)
Advertisement
Table of Contents
