Table of Contents
Advertisement
STEP 9:
• Slide two PILLOW BLOCKS (33) over the LEFT PIVOT ARM
(5) and LIGHTLY tighten the set screws on the PILLOW
BLOCKS (33) as shown in FIGURE 9.
48
25
27
28
2
47
33
23
3/8 X 1-1/4"
FIGURE 10
STEP 10:
• LOOSELY assemble the PILLOW BLOCKS (33) on the LEFT PIVOT ARM (5) to the CROSS SUPPORT (6) and the PIVOT ARM
SUPPORT (2) using four 3/8 X 1-1/4" BUTTON HEAD CAP SCREWS (23), four 3/8" SAE WASHERS (27), four RH WASHERS
(28), four STARLOCK WASHERS (47), four 3/8" LOW HEIGHT LOCK NUTS (25) and four RH CAPS (48) as shown in FIGURE
10.
• LOOSEN set screws on the PILLOW BLOCKS (33) on the LEFT PIVOT ARM (5) & RIGHT PIVOT ARM (4). Rotate both PIVOT
ARM (4 & 5) so that they contact each other and line up. TIGHTEN the PILLOW BLOCKS (33) on both PIVOT ARMS (4 & 5)
and to the CROSS SUPPORT (6) and PIVOT ARM SUPPORT (2). Adjust the PIVOT ARMS (4 & 5) up or down so that both arms
are the same height. TIGHTEN all PILLOW BLOCK (33) set screws.
4
23
3/8 X 1-1/4"
6
FIGURE 9
5
4d
5
10
33
TIGHTEN!
6
Advertisement
Table of Contents
