Table of Contents
Advertisement
FIGURE 15
CABLE
TIGHTEN!
15
STEP 15:
• SECURELY assemble the GUIDE ROD SUPPORT (9) to the TOWER (1) using four RH CAPS (48), two 3/8 X 2-1/2" BOLTS
(56), four 3/8" RH WASHERS (28) and two 3/8" LOW HEIGHT LOCK NUTS (25) as shown in FIGURE 15. (NOTE: Be sure to route
cable through the hole of the GUIDE ROD SUPPORT (9) before tightening.)
• Slide GUIDE ROD BUSHINGS (38) into the tubes on the GUIDE ROD SUPPORT (9), slide 1" SHAFT COLLARS (36) under-
neath the GUIDE ROD BUSHINGS (38) and SECURELY tighten the set screws.
• Screw the threaded end of the CABLE into the end of the shaft on the HEAD PLATE (15) until the CABLE is taut and tighten jam
nut securely. See FIGURE 15.
• Insert the WEIGHT STACK PIN (34) into the WEIGHT STACK as shown in FIGURE 15.
1/2
0
48
25
28
9
38
36
1/2
1
2
1/2
1/2
3
15
1
56 3/8 X 2-1/2"
TIGHTEN!
34
1/2
1/2
4
5
6
Advertisement
Table of Contents
