Table of Contents
Advertisement
FIGURE 16
SPRING PIN NUT
1/2 X 3-1/4" 24
SHOULDER
STEP 16:
• Insert the SPRING ASSEMBLY on the HANDLE (13) into the HOUSING on the RIGHT PIVOT ARM (4). Thread the nut into the
HOUSING and tighten SECURELY.
• Finish assembling the HANDLE (13) to the RIGHT PIVOT ARM (4) using one 1/2 X 3-1/4" SHOULDER BOLT (24), two 1/2"
FLANGE BEARINGS (37), one 3/8" LOCK WASHER (29), and one 3/8" ACORN NUT (26) as shown in FIGURE 16. (NOTE: Tighten
enough to allow HANDLE to lift up freely without sticking.)
54
56
3/8 X 2-1/2"
28
14
4
25
FIGURE 17
STEP 17:
• SECURELY assemble two FOOT SUPPORTS (14) to the RIGHT and LEFT PIVOT ARMS (4 & 5) using four RH CAPS (48),
four BLACK RH CAPS (54), four 3/8 X 2-1/2" (56), eight 3/8" RH WASHERS (28) and four 3/8" LOW HEIGHT LOCK NUTS
(25) as shown in FIGURE 17. (NOTE: Make sure FOOT SUPPORTS (14) line up VERTICALY before tightening. SEE INSET.)
13
TIGHTEN
HOUSING
4
BOULT
48
26
29
37
5
16
LINE UP!
Advertisement
Table of Contents
